Compatible with the SPI interface found on any SD card, this tiny form
factor was created for cell phone storage and is perfect for your next
3D printer project!
This
RAMPS add-on enables you to print from MicroSD.With RAMPS 1.3 or
higher. it's easily connected to the RAMPS board.You will be able to
print without being connected to your PC
SPI mode
Support voltage:4.5 to 5.5V
Up to 50 MB/sec data transfer rate
1 x Smart Borosilicate glass
Sits directly on a RAMPS.
Also be used with other microcontrollers
Board comes fully assembled and tested.
Package includes:
1 x TF SD Card SD Ramps Breakout Module Breakout Board
Note: all the descriptions and prices are subject to change without prior notice.
Free Shipping: No
Shipping Weight/Unit(g): 0.00
Std. Packing Qty. (pcs): 1
