Description:
When you us e
Ar duino Due as the controller of your 3D Printer, you may find the
RAMPS1.4 is not compatible with DUE.As you know the Ar duino Due is a
microcontroller board based on the Atmel SAM3X8E ARM Cortex-M3, the
importance is the Atmel SAM3X8E chip used on the Due operates at
3.3V,worse applying 5V to the Due's inputs will likely damage the chip.
So we create a new RAMPS variant which is compatible with the Due to replace Ramps1.4.
Why should I use Ramps-FD instead of Ramps1.4
Campare Ramps-FD with Ramps1.4,the Improvements of Ramps-FD are below
* The RAMPS-FD has other hardware protection, through the jumper cap control motor drive IC
* The RAMPS-FD Much more than Ramps1.4 2-way PWM
* The RAMPS-FD has Larger driving power than Ramps1.4
* The RAMPS-FD 'POWER has two choices:12v and 24v
Why should I select RAMPS-FD instead of Arduino Mega
* CPU operates at 3.3V
* High-current IO pins are capable of 15 mA source, 9 mA sink
* Low-current IO pins capable of 3 mA source, 6 mA sink
* CPU package has an absolute max of 130mA
*
The Due has 1 dedicated SPI port, and 4 multipurpose USART/SPI ports.
The SPI port is only routed to the 6 pin header used for ICSP on Mega,
but this is not used for ICSP on Due
* The Due does not have any EEPROM
* Due has lower power, computing faster and flash, sram bigger than mega2560
1 X RAMPS-FD Shield for Arduino DUE
Note: all the descriptions and prices are subject to change without prior notice.
Free Shipping: No
Shipping Weight/Unit(g): 0.00
Std. Packing Qty. (pcs): 1
Report an Error (Win $10 Prize)